When the furnace quits on a cold East County morning, you want a straight answer and a fast fix — not a hard sell on a whole new system. In Gresham that's exactly what we do: diagnose it honestly, repair it when it's the right call, and only talk replacement when the numbers actually say so.
A lot of the furnaces we see in Gresham and out toward Troutdale are 12–20 years old and have plenty of life left with the right part. Our techs troubleshoot the actual failure — igniter, flame sensor, pressure switch, blower motor, control board — before anyone mentions a new system. If a repair gets you several more good seasons, that's the recommendation. The $0 diagnostic when you proceed with the repair means an honest look doesn't cost you anything extra.
No heat, short-cycling, a furnace that lights then drops out, loud startups, or a unit tripping on its high-limit — most come down to a handful of parts and a proper combustion check. We carry the common ones, test safeties (including the heat exchanger and CO side of things) on every visit, and don't hand the furnace back until it's actually running right.
Sometimes the heat exchanger is cracked or the repair cost is most of the way to a new, far more efficient system — and for an older Gresham home a heat pump may qualify for $2,000+ in rebates. When that's the case we'll show you the math plainly so you can decide, with no pressure and no overtime charges.
No-heat call on a cold Gresham morning — diagnosed a failed igniter and pressure switch, replaced both, and ran a full combustion and safety check. Back up and running the same visit.
No-heat call in Gresham — diagnosed and repaired the failed component, with a full combustion and safety check before leaving.
Call now or send us a few details and we'll get back to you fast.